Component replacement parts.
To allow variable heights without marring the part.
To allow variable heights of up to 0.5″ [22mm] and then lock into position.
For positioning a component at any angle. Lock the rotating base into position and then set the angle of the pivot.
For holding cylindrical or tubular parts without marring the part’s surface. Can be rotated and locked to any orientation.
For holding cylindrical parts at each end on their inside diameters. These are ideal for vision machine applications to allow complete visibility of the part.
Non-marring setup clamp for securing fixture bases to a CMM.
For allowing a part to be located in a corner.
For holding contour surfaces.
For holding steel or iron parts.
For holding cylindrical parts.
Has adjustibility to hold cylindrical parts up to 26mm in length and 25mm dia. (or smaller) using a female or male tapered pin.
For holding parts in a V with a spring arm and adjustable end stop.
Ideal for holding parts horizontally or vertically with minimum contact on the part.
For clamping a small area of a part.
Allows locking the tension clamp rotational position to avoid probing interferences from one time to the next.
To push a part against standoffs or into corner. Two interchangeable tips are included.
To rest a part on a rounded point for single-point contact.
For pushing and holding a part against stops by way of screwing the thumbscrew in and out to release pressure on the part.
With rubber coated tips for light clamping of small parts minimizing the contact area on a part and for least possible obstruction on vision machines.
CWT-2-2-20 and CWT-1-1-20 shown in image.
Rubber coated tips hold parts without scratching or marring the surface of a part.
For securing parts using a downward force, best if used in conjunction with wedge stop on opposing sides.
For light clamping of small parts minimizing the contact area on a part and for least possible obstruction on vision machines.
CW-50-50-4 and CW-25-25-4 shown in image.
For holding plastic, glass, styrofoam and nonferrous parts.
For holding and organizing 1/4-20 or M8 suction cups.
For quick and easy clamping.
For holding round and shaft parts.